Log a flight in UTC, past midnight
1. Choose UTC or local time
Section titled “1. Choose UTC or local time”On Log Flight’s Total step, the clocks start in each airport’s local time unless your Time zone setting is UTC (or no zone has been chosen), in which case they start in UTC. Tap the route card at the top to switch between the two (VoiceOver reads Times shown in airport local time. Tap to switch to UTC.; on screen the card shows the zone as a small suffix after the times: -7 for local, z for UTC). It only changes how you type and read the times on this flight; it doesn’t change your settings. Your usual starting zone is in Account → Settings → Time zone (see Settings explained).
Under each clock is the same time in the other zone (in UTC mode: 16:30 UTC-7 under 23:30).
2. Type the times
Section titled “2. Type the times”With OOOI selected under Where does block time come from?, tap each clock and type the time as four digits (for example 2330, 2340, 0015, 0025, all UTC). Tap Done on the keyboard bar. Durations such as Block read digits differently: see Type a duration fast, and why ‘50’ means 50 hours.
- A clock that’s later than midnight compared with OUT gets +1 (or +2): here ON +1 and IN +1. The marker sits beside the clock’s name and follows the zone the route card leads with: here UTC, so ON and IN are on the next UTC day. When local leads, it follows each airport’s local date, so this flight (16:30 to 17:25 local, all on 8 October) shows no mark in local time.
- Block (OUT → IN) and Air (OFF → ON) are worked out across midnight: 0:55 and 0:35.
Tap each clock directly. Next on the keyboard bar doesn’t go OUT → OFF → ON → IN in order; it can jump into Block and Air. If a tap only highlights the clock, tap it again to get the keyboard.
3. Nudge a time
Section titled “3. Nudge a time”Tap a clock that already has a time: NUDGE OUT TIME · Spin to correct opens, a strip you drag sideways to move the time in minutes (it covers two hours in all, an hour either side of the time you tapped). Tap × to hide it.
If the times stop making sense, a red line warns: That is a 20+ hour block time — check OUT and IN.
4. Save it
Section titled “4. Save it”Tap Complete. The flight’s page opens (Thu, Oct 8, 2026 · KPAO → KMRY · 1:01). Tap Total Flight to jump to the times: ON and IN are 17:15 and 17:25 local (00:15 and 00:25 UTC), and block is still 1:01. In local time they’re on the same day as OUT, so there’s no +1; switch the times to UTC to see it.