Change an auto-filled time
Your role profile fills times for you (see Role profile and auto-fill explained). You can change any of them on one flight without touching the profile.
On the Times step
Section titled “On the Times step”Log Flight → New Flight, then go on to Times. Filled times are grouped by value, for example 1:42 T: P1, XC. T means the time follows the total; A means it follows air time. Empty times wait below as + chips, for example + P2, + Dual Rcvd.
| To… | Do this | What you see |
|---|---|---|
| Use a different value | Tap the time, then type in the box (1:30 or 0130; 130 would be 13 hours, see Type a duration fast, and why ‘50’ means 50 hours) and tap Done |
The chip shows YOUR VALUE and a ■; it no longer follows the total |
| Follow the total again | Open it and tap T | It shows FILLED BY ROLE again and follows the total |
| Follow air time instead | Open it and tap A | It follows OFF→ON time |
| Fill an empty time | Tap its + chip | It’s filled from the time its letter shows (T total, A air time) and linked to it |
| Remove a time | Tap the × on the chip, or Clear in its editor | It moves back to the empty row |
XC fills itself only when the route reaches your role profile’s minimum distance (50 nm). Under it, XC waits as + XC; tap it to fill this flight’s XC from the total. See Is it cross-country? Watch the 50 nm rule fill XC.
Night and instrument time
Section titled “Night and instrument time”NIGHT and A.INST open an adjuster. You can turn the wheel, type a time (capped at the maximum), or tap a preset (5%, 10%, 25%, 50%, 75% of the total; 25% of 1:42 is 0:26). max fills the whole flight. On A.INST, the NT row sets how much of it was at night (up to the route’s night). If your role profile fills that time automatically, changing it adds a recompute arrow that hands it back to the rule.
Only this flight
Section titled “Only this flight”These changes apply to the flight you’re logging. Your role profile, and future flights, are unchanged. To change what fills automatically for every flight, use Logbook Fields in your role profile.